PROCEEDINGS
of
the First International Conference
on
Fluid and Thermal Energy Conversion
pp.i.
PREFACE
pp.ii.
LIST OF CONTENTS
pp.1-6:
EXPERIMENTAL STUDY OF A TYPICAL REFRIGERATOR CHARACTERISTIC AT START-UP PERIOD
Prihadi Setyo Darmanto And Rachmad Arifandy
pp.7-12:
PREDICTION OF FROST FORMATION AROUND A VERTICAL CYLINDER SUBJECT TO CROSS WET AIR FLOW
lsmail, K. A. R. and Scalon, V. L.
pp.13-16:
FLOW VISUALISATION AND FLOW UNSTEADINESS IN A TURBINE BLADE CASCADE
Adjlout, L.. Imino, O., Ennacer, M. and Miloud. A.
pp.17-22:
IDEAL CYCLE ANALYSIS OF A HIGH-PRESSURE MICRO-COMPRESSOR FOR DIRECT INJECTION GAS FUELLED ENGINES
F. Bruno, S. De Maria and W. Saman
pp.23-28:
COMPUTATION AND COMPARISON OF PARTICLE-LADEN GAS FLOW IN AN IN-LINE TUBE BANK
J. Y. Tu, C. A. J. Fletcher and J. A. Reizes
pp.29-34:
LAMINAR AND TURBULENT HEAT TRANSFER PREDICTIONS IN TUBE BANKS IN CROSS FLOW
F. Zdravistch, C. A. J. Fletcher and M. Behnia
pp.35-39:
DYNAMIC BEHAVIOUR OF AN ABSORPTION HEAT TRANSFORMER
C. Z. Zhuo And C. H. M. Machielsen
pp.39-44:
EFFICIENCY OF HYDRAULIC ACCUMULATOR FOR ENERGY STORAGE DEVICE
Yutaka TANAKA end Kazuo NAKANO
pp.45-50:
EFFECTS OF THE PULLING RATE ON THE INTERFACE CURVATURE DURING THE CZOCHRALSKI SILICON- CRYSTAL GROWTH
M. G. Kim. C. J. Kim and S. T. Ro
pp.51-56:
DESIGN AND MODEL TESTING OF A WIND TURBINE FOR WATER PUMPING IN DEVELOPING COUNTRIES
W. Y. Saman and M. Y. Hanna
pp.57-62:
PYROLYSIS OF WOOD CHIPS
Arshad, Ahmad Sabirin, Griffiths, A. J. and Syred. N.
pp.63-68:
TECHNO-ECONOMICAL DESIGN AND ANALYSIS OF COGENERATION SYSTEM BY STEAM BACK PRESSURE TURBINE
Rachmat Novirsal, Raldi A. Koestoer and Yus Sadewo
pp.69-74:
MIXED CONVECTION IN INCLINED PARTITIONED CHANNELS WITH LOCALIZED HEATING SOURCES
A. Raji, M. Hasnaoui and Z. Zrikem
pp.75-78:
THE STUDY OF THE STRUCTURE TURBULENT FLOW BETWEEN TWO PARALLEL ROUGH-WALLS
Mazouz A. , Labraga L. , Tournier C. and Florent P.
pp.79-84:
EFFECT OF OIL RECOVERY ON BIOLOGICAL STATE OF AZERBAWAN SEA COAST OF THE CASPIAN SEA
IFFET M. EFENDlYEVA
pp.85-90:
FLUID POWER FOR INDUSTRIAL AUTOMATION-STATUS AND PROBLEMS
Peter DRANSFIELD
pp.91-96:
THERMAL STABILITY STUDIES OF SOME COMMON POLYMERS IN DRILLING FLUIDS FOR GEOTHERMAL DRILLING
Le, Q.V., KhAn, F.A.and Rahman,S.S.
pp.97-102:
NATURAL CONVECTION HEAT TRANSFER IN HONEYCOMB ENCLOSURES WITH PERFFCTLY CONDUCTING FINS
E. K. Lakhal, M. Hasnaoui, E. Bilgen and P. Vasseur
pp.103-108:
AN EXPERIMENTAL INVESTIGATION ON DRYING PROCESS OF MOIST PAPER IN FORCED CONVECTION
Koji YAMAZAKI, Hakaru SAITO, Koki KISHINAMI and Jun SUZUKI
pp.109-114:
AN EXPERIMENTAL STUDY ON THE SOLIDIFICATION AND MELTING PROCESS AROUND THE HEAT TRANSFER TUBE WITH SPLIT FINS
Yoshio HIRASAWA, Eisyun TAKEGOSHI, Hiroshi KONYA, Akio KOSAKA and Ikuo TAJIMA
pp.115-120:
DEVELOPMENT IN HEAT TRANSFER ASPECTS OF SOLAR ENERGY UTILISATION
Norman Sheridan
pp.121-128:
PRESSURE WAVE PROPAGATION IN AN ELASTIC FILLED-TUBE SUBJECTED TO A SHOCK LOADING
D. A. SUMARSONO and Raldi Artono KOESTOER
pp.129-136:
ASCENT OF A PARCEL OF MOIST AIR THROUGH A STANDARD ATMOSPHERE
J. Entesari-Tatafi, E R. E. Luxton and 1. Koptchev
pp.137-144:
RETROFIT STRATEGIES IN THE PROCESS INDUSTRIES USING PINCH TECHNOLOGY
Zainuddin A. Manan and Kamarul A. Amminudin
pp.145-150:
THEORETICAL AND EXPERIMENTAL RESEARCHES RELATED TO THE UTILIZATION OF VORTEXTUBES FOR AIR CONDITIONING
Bnran Nicolae
pp.151-156:
COMPARATIVE STUDY OF WAKE DEVELOPMENT AS FUNCTION OF BODY GEOMETRY
Madeleine COUTANCEAU, Patrick EHRMANN and Nathnlie BOISAUBERT
pp.157-162:
CONVECTIVE HEAT TRANSFER IN AN ANNULAR ANISOTROPIC POROUS LAYER WITH CENTRIFUGAL FORCE FIELD
K. ABOUBI, L. ROBILLARD and E. BILGEN
pp.163-172:
LOCAL BOILING RATES IN HORIZONTAL COCURRENT FLOW
Ali Nouri-Borujerdi
pp.173-178:
Xe POISONING IN TRIGA MARK 11 OF BANDUNG
Aman MOSTAVAN and Erwin ARIADHARMA
pp.179-192:
HEAT AND MASS TRANSFER WITHIN A FIBERGLASS HOUSE SOLAR DRYER
Kamaruddin A., Armansyah T., Tamrin, F. Wenur and Dyah
pp.193-200:
GRAPHICAL DETERMINATION OF VIRIAL COEFFICIENTS AND ITS COEFFICIENT OF EXPANSION IN TEMPERATURE BY BURNETT METHOD (HELIUM AND CARBON DIOXIDE)
1. M. Kartika Dhiputra, Budihsrdjo, Nakoela Soenarta
pp.201-208:
VISCOUS DAMPING ARISEN ON THE VIBRATING SLENDER STRUCTURES IN THE OCEAN ENVIRONMENT
Gde Prndnyana
pp.209-214:
LIOUEFIED NATURAL GAS TECHNOLOGY
Chen-Hwa Chiu, Frank W. Richardson
pp.215-222:
NUMERICAL MODELING OF CHEMICAL KINETICS TO SIMULATE THE CONVERSION OF INTERNAL TO KINETIC ENERGY IN NOZZLES
R. Pasciorri and M. Onofri
pp.223-228:
CFD MODELLING OF STRONGLY CURVED SURFACE WAVE PROFILES
Wan Ali Wan Mat and Alexander Anderson
pp.229-234:
CFD MODELLING OF UNSTEADY JET IMPACT ON ARBITRARY CURVED BOUNDARIES
Wan Ali Wan Mat and Alexander Anderson
pp.235-240:
CONJUGATE HEAT TRANSFER AROUND A DISSIPATING OBSTACLE LOCATED IN A CHANNEL: DIFFERENCES BETWEEN 2D AND 3D MODELIZATIONS
J. B. SAULNIER and B. FOURKA
pp.241-246:
STEADY SWIRL MEASUREMENT IN AN ENGINE CYLINDER
R. BENNAR HARROUCH and D. G. THOMAS
pp.247-252:
THE EQUIVALENCE RAT10 INFLUENCE ON THE INSTANTANEOUS THERMAL FIELD IN LOW DAMKOHLER REACTING FLOWS
A. BOUNIF, L. KADI and 1. GOKALP. F. GAILLARD
pp.253-258:
THE SPRECTRAL BEHAVIOUR OF THE INSTANTTANEOUS THERMAL FIELD IN THE REACTING AND NON-REACTING FLOWS IN A JET-STRRED REACTOR
A. BOUNIF, L. KADI and 1. GOKALP. F. GAILLARD
pp.259-264:
STUDY OF FREE CONVECTIVE HEAT TRANSFER BETWEEN VERTICALLY ECCENTRIC SPHERES
M.N. TAZI CHARKI, G. LE PALEC, S. DAOUDI and M. DAGUENET
pp.265-268:
SIMULATION OF CRYOGENIC FAST FREEZING PROCESS
A. D. P Is-k, 1. M. Astina and A. Suwono
pp.269-274:
NUMERICAL STUDY ON HEAT TRANSFER IN A MULTICOMPONENTS MATERIAL BETWEEN TUBES ARRAY DURING MELTING PROCESS
S. Himran, H. M. Samudro, Sularso, A. Suwono and G. A. Mansoori
pp.275-280:
DETERMINATION OF THE LIQUIFIED NATURAL GAS DENSITY
M. En-nacer, L. Adjlout and 0. Imine
pp.281-286:
EFFECTS OF CIRCUMFERENTIAL PRESSURE DISTORTION ON THE EXIT FLOW OF A CENTRIFUGAL COMPRESSOR
K. V. MURALI, N. BALAJI RAO, N. SITARAM, M. GOVARDHAN and N. VENKATRAYULU
pp.287-292:
THE PERFORMANCE OF GIBSON-TYPE STEPPED CONICAL DIFFUSERS WITH ASYMMETRIC UNIFORM SHEAR INLET FLOW
Katsuya ISHIKAWA nnd Ikuo NAKAMURA
pp.293-302:
COMPRESSED AIR REFRIGERATION TECHNOLOGY FOR AEROSPACE COATING APPLICATIONS
Ly D. Nguyen
pp.303-314:
A NUMERICAL SOLUTION OF FLUID AND HEAT FLOW IN A TRIANGULAR ENCLOSURE
Mat Nawi Wan Hassan
pp.315-320:
CHARACTERISTICS OF TRAILING VORTEX PRODUCED BY A FAN TURBINE
S. Winardi, H. Setyawnn and H. Ismarwanto
pp.312-326:
TURBULENT MIXING IN STIRRED TANK WITH MULTIPLE IMPELLER SYSTEMS
S. Winardi, H. Setyawan, D. D. Puspito. R. Hartono and N. Suwarno
pp.327-332:
HEAT EXCHANGER OPTIMIZATION An Application of Exergo-Economic Analysis
S. Alvarado, H. Auracher and C. Gherardelli
pp.333-352:
DEVELOPMENT OF SOLAR THERMAL WATER PUMP SYSTEM USING A PNEUMATIC DIAPHRAGM PUMP
HARINALDI, R. WIJAYA KUSUMA. HATUAN A. W RITONGA. M. IDRUS ALHAMID
pp.353-360:
WAX PRECIPITATION FROM CRUDE OILS
Rahoma S. Mohamed and Paulo C.S.dos Santos
pp.361-370:
PHASE BEHAVIOR OF BRAZILIAN ASPHALTENIC CRUDE OILS
Julio C. Moreira and Rahomn S. Mohamed
pp.371-374:
INDEX OF TITLES
pp.375-376:
INDEX OF NAMES
| FTEC Mail Box |
